VORON TAP 配置文件

VORON TAP 配置文件

配置文件

# Updating your Klipper config for Tap

There are a few changes you'll need to make in order to get Tap working properly.

1. Update your Z endstop: 
   
   - Under the `[stepper_z]` block, you'll want to comment out your `position_endstop` and change your `endstop_pin` so that it uses the virtual Z endstop for Tap.
   
      - Example: `endstop_pin: probe:z_virtual_endstop`
   
   - Be sure to *also* remove any automatically saved `[stepper_z] position_endstop: ...` value that may be found at the **bottom** of your `printer.cfg`file.

2. Update your Z homing position: 
   
   - If you use `[safe_z_home]`, change the location to the center of the bed. If you have a `[homing_override]` make sure that it moves the toolhead to the center of the bed before calling `G28 Z`.
   
3. Update your probe's offsets: 
   
   - Remember, with Tap, your nozzle IS the probe, so your `[probe] x_offset` and `[probe] y_offset` values should be 0 now. You'll need to manually calibrate the probe's Z offset by using `PROBE_CALIBRATE`.
   
4. Add Tap's `activate_gcode:`  
   
   - This G-code will allow you to probe cold, but will also prevent you from probing with a nozzle at printing temperature (to try to preserve your build surface). This goes in the `[probe]` section of your config.  

宏命令

分享此文章

发表回复

您的电子邮箱地址不会被公开。 必填项已用*标注